LEGO Game Boy Build Kit + Electronics (ESP32-S3 preloaded games)
$95
Take on your next ultimate DIY project! This listing features a newly assembled third-party LEGO Game Boy set paired with the core electronics needed to turn it into a playable retro emulation handheld running Retro Go.
Using LEGO pieces from the cartridge stand build, the 2.4-inch display, ESP32-S3 board, and 2 tactile buttons (A & B) have been custom-mounted inside the housing. The unit is set up with an open-back style for easy wiring access, but all original LEGO pieces are included to return the build to standard display form if preferred.
Pre-Loaded & Ready to Demo:
Retro Go boots up smoothly and comes pre-installed with 7 classic titles directly on internal memory to get your feet wet:
Contra
R-Type
R-Type II
Super Mario
Tetris
Tetris 2
Tetris War
To expand your library with countless more games, simply connect the included SD card module with a micro SD card of your choice!
Wiring & Electronics Setup:
Included Pinout Reference Sheet: A detailed ESP32-S3 Retro Handheld Pinout Reference guide is included to make wiring up your display, buttons, sound, and SD card reader simple and straightforward.
Current Wiring Status: The bench-testing wires shown in photos were used to verify display and firmware functionality. The buttons, audio, and SD card reader are mounted/included but currently unhooked so you can run your own clean layout.
Display Note: The original protective plastic film is still on the screen to prevent scratches (which is why screen photos may look slightly off).
What’s Included:
Third-Party LEGO Game Boy Set: Complete set (currently configured in modified open-back housing, plus all extra bricks to restore standard build).
Printed ESP32-S3 Pinout Reference Guide Sheet.
ESP32-S3 Microcontroller: Flashed with Retro Go firmware + 7 internal games.
2.4-Inch Display Screen: Pre-mounted into frame (protective film still attached).
Speaker & Audio Amplifier Module.
SD Card Reader Module.
USB-C Battery Charging Circuit Board.
Tactile Switches: 2 mounted into the LEGO housing (A/B buttons), plus remaining switches.
What’s NOT Included:
Wires: Testing jumper wires shown in photos are not included. You will need your own thin silicone wire (28-30 AWG recommended) so it won't get in the way inside the shell.
Micro SD Card (7 games pre-loaded on internal flash; add your own SD card for more).
Battery.
USB-C Cable.
Condition:
Brand new components, assembled for testing and setup verification. An awesome hands-on project for retro gaming enthusiasts, modders, and LEGO tinkerers!
- ConditionNew
WHERE TO MEET
SELLER

Jason
Richview
493 reviews
0 chats5 favorites113 views





