resin

I'm selling 10,5kg of EPOXYPLAST 3D B50 DEEP POUR epoxy resin IM SELLING IT FOR A LOWER PRICES SO GET IT WHILE YOU CAN 😉 £100 only About this item ✅ MAXIMUM UV RESISTANCE: The new EPOXYPLAST 3D B50 DEEP POUR Formula contains the highest possible UV Resistance for epoxy resins. Including HALS & UV-Absorber ✅ ULTRA DIAMOND CLEAR: Crystal Clear was yesterday! Witness the most advanced Ultra Diamond Clear Casting Resin. The all new B50 cures like a Diamond. ✅ SAFETY: EpoxyPlast 3D is Non-toxic, BPA-free, No VOCs. Solvent-free. Odorless. Non flammable and not explosive. ✅ DEEP CASTING: Formulated for Deep Casting like River Tables, Lamps, huge moulds or any comparable projects. ✅ EASY APPLICATION: 2:1 mixing ratio by weight, self-leveling, bubble-free. Formulated for the most advanced results in commercial and private use. MADE IN GERMANY. Description DIPON Epoxy Plast 3D is a low-viscosity and highly transparent epoxy resin with an excellent UV resistance for a wide range of applications, such as highly transparent glass-like or coloured artistic and decorative applications. From the smallest embeddings and coasters to very large transparent greetings such as River Tables or large transparent greetings. EPOXYPLAST 3D distinguishes its excellent clarity, UV stability, excellent self-ventilation and easy handling. Directions for use: EPOXYPLAST 3D B50 DEEP POUR is precisely weighted in a clean container at a mixing ratio of 2:1. A scale and two mixing cups are required to allow for precise weighing and mixing. Please do not mix according to volume, as this can result in a faulty result. First mix the A and B component with max. 300 revolutions per minute for approx. 3 - 4 min. to The A+B mixture is then potted into a clean container and again three to four minutes. Mixed. Scrape parts of the resin from the edges of the old container and drip them into the new one. This process is important in order to obtain the most homogeneous mixture possible. Important note: A (resin) and B (hardener) containers will result in a non-occurring full curing and corresponding faulty result. If your resin (A-component) is milky, clumpy or firm this is a crystallisation. This process is caused by cold and is reversibly controlled by a water bath (50-70 °C). Store the resin closed at room temperature and avoid temperature falls, high humidity and direct sunlight for a longer period of time. Application advice: Always primer with EPOXYPLAST 3D B20, EPOXYPLAST 100 P or HoneyResin for porous or absorbent surfaces (e.g. concrete, wood).