Near Screen Accurate Proton Pack *No Electronics*

I made this Proton Pack from a "BenofKent" kit (resin and aluminum), and screen accurate hardware. Pack weighs about 25lbs but feels much heavier. I have added weathering to the particle thrower but left the proton pack clean, If the buyer wants, I can add weathering to the pack for an extra $200 *notes* - Added the red stripe around the N-filter, as well as the two stickers on the bottom of the particle thrower after I filmed the video. Pictures are included. - I noticed after taking initial pictures that the blue cable on the top of the ion arm was kinked, so I replaced with a non kinked cable (as seen in the included video) - The Brass Banjo fittings that are on the thrower were impossible for me to get my hands on, so I made them from wood, sanded down and painted similar to the real Banjos. - I really liked the look of the Afterlife injector cable strain relief joints, and primary power switch (under ion arm) so I added those. - No electronics included, however I've drilled out and prepped for an easy install for whoever buys this pack. The motherboard has both the cyclotron and power cell risers installed to the motherboard. - Particle thrower is prepped for electronics, has and I provided enough space to install the "pop mechanism, (which is also not included)" Aluminum parts are as follows: - Ion arm - Booster tube - Gun ring - V-hooks - S-hook - Ribbon cable clamp - Shock Mount - Particle thrower handle tubes (grips are resin) - Particle thrower bottom cover, and rear "slow-blo" cover Authentic parts: - Dale PH-25 Resistor - Legris Elbows - Brass Clippard Elbows and Barbs - GB2 Ribbon Cable - LC1 Alice Frame - Split Loom hose from pack to thrower - Primary Power switch (under ion arm)

• ConditionNew